Remove propeller when first programming any radio for aircraft. Then reverse all throttle channels to up position for all model memories. There are 2 versions of the T7C transmitter. One is mode 1, the other is mode 2 transmitters. The throttle ratchet is easily change from one side to the other. A brief explanation showing how to set a throttle curve for the Futaba 16SZ/18SZ for a helicopter. Includes a small explanation about checking the servo moni Heat both sides evenly. I alternate (using a stop watch) 60 seconds on one side moving the heat side to side and then 60 seconds on the other side, moving up and down along the area to be bent. Keep the heat gun at least an inch from the plexi or you risk overheating an area and causing it to bubble. Send the transmitter and receiver to the Futaba service center for testing and tuning. Using a synthesized receiver: To set the frequency on the R309DPS synthesized receiver, unplug the receiver battery. 1) Set ATV for both flaps at 140%. Set this for both sides of the flap travel. 2) Offset the flap servos by 50%. 3) Use 88% of flap stick travel for flap deployment. This is an arbitrarily chosen number but the amount of stick travel you choose will affect the total servo travel available for flap deployment.
1. Start with the transmitter ON, the battery disconnected, and the ESC switch in the OFF. Plug a battery into the ESC - If your ESC does not have a switch, hold full throttle on your transmitter before plugging in the battery. 2. Hold full throttle on the transmitter and turn the ESC switch ON. 3. Keep holding full throttle on the transmitter.
Note: The model data in the transmitter can be used unchanged after updating, but to be safe, back up the model data before updating. Download the zip file of the update data from our website. Extract the zip file on your computer. The “FUTABA” folder will be created on your computer. Copy the “FUTABA” folder info your microSD card.
Futaba transmitter manual for instructions on reversing the throttle channel. Transmitter and Receiver Binding Binding Procedure Reference Table 1. Refer to your transmitter instructions for binding to a receiver. 2. Make sure the fl ight battery is disconnected from the aircraft. 3. Ensure the transmitter is powered OFF. 4.
But don't worry, easier to set up this program than any real models. In this example I'll use a Futaba T8FG transmitter. Futaba T8FG Choose a new model memory. This is in the linkage menu's model sel. entry. Choose the new. The transmitter will ask you to confirm, what can be done by pressing the RTN button of the jog for 1 second. QQL2.
